1
SP103
PIR DETECTOR
The PIR Detector is a Z-Wave
TM
enabled device and is fully compatible with any
Z-Wave
TM
enabled network. Z-Wave
TM
enabled devices displaying the Z-Wave
TM
logo can also be used with it regardless of the manufacturer, and ours can also be
used in other manufacturer’s Z-Wave
TM
enabled networks. This PIR Detector is
controllable to our modules, such as On/Off Module AN135 and Lamp Module
AD130. Inclusion of this PIR Detector on other manufacturer’s Wireless Controller
menu allows remote turn-on of connected modules and their connected lighting
when the Detector is triggered.
The PIR Detector is designed to detect movement in a protected area by detecting
changes in infra-red radiation levels caused, for example, when a person moves
within or across the devices field of vision, a trigger radio signal will be transmitted.
Adding to Z-Wave
TM
Network
In the rear casing, there is a tamper switch which is used to carry out inclusion,
exclusion or association. Put a Z-Wave
TM
Wireless Controller into
inclusion/exclusion mode, press the tamper switch on the detector to complete the
inclusion/exclusion process (FIGURE 1)
Choosing A Mounting Location
The recommended position for a PIR Detector is in the corner of a room mounted
2m from the floor. At this height, the detector will detect movement up to 6-12m
depending on adjustment. (FIGURE 2a) Also, in this position, the 110 degrees
fan-shaped detection pattern can normally offer greater protection than mounting on
a flat wall. Before selecting a position for a PIR Detector the following points should
be noted:
1. Do not position the detector facing a window or direct sunlight. PIR Detectors
are not suitable for use in conservatories or draughty areas.
2. Do not position the detector directly above or facing any source of heat, eg: fires,
radiators, boiler etc.
3. Where possible, mount the detector so that the logical path of an intruder would
cut across the fan pattern rather than directly towards the detector.(FIGURE
2b)
FIGURE 2a FIGURE 2b
Installation
1
Front Cover
4
Battery
2
PIR Motion Sensor
5
Rear Cover
3
Time-off Knob
6
Tamper Switch
1. Using a Phillips screwdrivers to detach the rear cover. (FIGURE 3a)
2. Insert 2 AAA-size 1.5V batteries to the battery compartment, ensuring that
6
0
2
2.0
2
0
10
6
(M)
10
(M)
100
°
4
8
4
8
2
4
6
8
10
