- 3 -
Inclusion
1. Put the Z-Wave Controller into inclusion mode.
2. Press the link key three times within 1.5 seconds to
put the unit into inclusion mode.
Exclusion
1. Put the Z-Wave Controller into exclusion mode.
2. Press the link key three times within 1.5 seconds to
put the unit into exclusion mode.
Reset
(This procedure
should only be used
when the network
primary controller is
inoperable.)
1. Press the link key three times within 1.5 seconds to
put the unit into exclusion mode.
2. Within 1 second of step 1, press link key again and
hold until LED is off (about 5 seconds).
3. Node ID is excluded. The device reverts to factory
default state and will be in auto-inclusion mode for 4
minutes.
Failed or successful results in including/excluding the ID can be viewed on the Z-Wave Controller.
Note
: If you are connecting this unit to a Z-Wave Controller that utilizes the S2 security protocol, you may be
asked to enter a 5 digit Device Specific Key (DSK) that is unique to each unit by your controller. This can be
found in one of two places:
- on the QR code label on the back of the unit
- on the insert card inside the packaging
Table below lists typical problems encountered:
Symptom
Cause of Failure
Recommendation
Device not responding and
LED not displaying
The device is not wired to the
mains power correctly
Check if wiring is correct, or
voltage is too high or too low
Device malfunction
Send the device to be repaired
LED displaying, but cannot
control On/Off status of
connected load
The connected load has its own
on/off switch
Turn the switch of the
connected load to On.
Cannot control by RF but
switch control works.
RF interference is occurring.
Someone nearby might be
emitting RF signal of the same
frequency
Wait for a while and retry the
operation
Specifications
Frequency Range
EU: 868.42MHz, AU: 921.42MHz
Power Input
AC230V,50Hz
Maximum Power
Load(AC230V)
Resistive Load: 2x1000W, or 2 x 4.3A
Incandescent lamp load: 2 x 800W
Fluorescent lamp load: 2 x 120W
LED: 2 x 100W
Transmission Range
70 meters (Indoor open area with antenna outside of wall box )
Working Temperature
-10°C - 40°C
*Specifications are subject to change without notice
Warning:
Do not dispose of electrical appliances as unsorted municipal waste. Please use separate collection facilities
instead.
Contact your local government for information regarding the available collection systems.
If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the
groundwater and get in to the food chain, damaging your health and well-being.
When replacing old appliances, the retailer is legally obligated to take back your old appliances for disposal
free of charge.
www.everspring.com
3F., No. 50, Sec 1, Zhonghua Rd., Tucheng Dist.,
New Taipei City 23666, R.O.C
