22
Setup Guide
Getting Started
location for proper polarity. The design of the unit means that the
plasma torch does not have its own dedicated connector or terminal.
This terminal must be shared with the TIG torch. The plasma con-
nector is a 30/50 DINSE Type, but is a special connector designed
for use with the Plasma torch only. The
“
control
”
connector functions
as the connection for the torch switch. Additionally, this torch fea-
tures a pilot arc. The torch arc will not light or will fail to maintain an
arc (after the torch loses the cut) if the Pilot arc wire is not connect-
ed. The center Pilot Arc thumb screw is in use only used when plas-
ma cutting. Nothing should be connected to it while stick welding or
TIG welding.
Summary of Contents for PowerPro 164Si
Page 46: ...46...
