Customer Service 1-888-707-1880
Or email [email protected] 20 Dyaco Canada Inc.©2019
GENERAL MAINTENANCE
The safety of this product can be maintained only if regular periodic checks are made. Most
checks can be performed once a week. However, some checks should be made before each
workout, and are indicated as such below.
Checks
• Check that pedals hardware is secure, hardware can work loose over time.
• Check that stabilizer bolts are tight, check before each workout.
• Check that sliding rail is secure, if not, tighten, check before each workout.
• Should a part become defective, replace it immediately. Do not allow use of the equipment
until it has been repaired.
Cleaning
A damp cloth is sufficient to clean most surfaces of this unit. Be careful not to drip water onthe
monitor. A mild liquid soap may be added if needed.
HOW TO ADJUST THE SENSOR
If the console does not display correct feedback, the sensor should be adjusted. To adjust
the sensor, the pedal support tube (18) & the chain cover (43) must first be removed.
The first step to remove the two sets of carriage bolt (19), washer (17) and domed nut (7).
The second step to remove the two self
‐
tapping screws (64) from each side of chain cover (43).
And then remove another seven ST5 x 15 round head self tapping screw (50) from right chain
cover (43R).
The third step is to loosen the screw (50), rotate the sensor bracket (56) aligned with the
magnet on the pulley until the computer receive signals and tighten the screw (50).
The last step is attach the chain cover (43) & pedal support tube (18) on main frame.
14R
18
7
19
17
7
19
17
14L
50
64
64
64
50
64
50
50
50
50
50
