Date
: 21/09/2016
1 of 5
Released/Product Information/Pumpwell
(Poly) V1.0
POLYMER PUMP WELL
1000 L
82202C
Tested to comply with AS/NZS 1546.1 (2008)
Assembly and Installation Instructions
for on-site domestic waste-water treatment and disposal systems
PARTS SUPPLIED WITH EACH POLYMER PUMP WELL:
1:
1 x moulded Plastic Pump Well Assembly
2:
1 x moulded Plastic Access Cover
3:
6 x Stainless Steel Screws
4:
2 x standard elastomeric rubber rings for 100mm uPVC SWV pipe
PARTS SUPPLIED WITH EACH RISER KIT:
5:
1 x 600mm x 630mm dia Ribstruct
6:
6 x Stainless Steel Screws
7:
1 x Black Butyl Joint Tape (97681)
(Complete single pump and duty/standby pumpwell kits are available on request)
* Check with your local authority before selecting any part of a Waste-water disposal system.*
Refer Notes on back page.
The Polymer Pump Well should be located in areas not exposed to any vehicle or regular pedestrian
traffic. It should be installed in an area set aside for garden use, and finally covered with bark or garden
mulch after installation is complete. Where the Pump Well is in a high water table area extra anchorage
may be required.
See "ANCHORAGE"
.
Australian
Standard
AS/NZS1546.1
Lic 1950
Septic Tanks
