3
•
1 Instruction manual
•
Clean the interior surface with lukewarm water using a soft cloth.
¾
Installing Your Refrigerator
•
This appliance is designed to be free standing only, and should not be recessed or built-in (Fully recessed).
•
Place your refrigerator on a floor that is strong enough to support the refrigerator when it is fully loaded.
•
Allow 5 inches of space between the back and sides of the refrigerator, which allows the proper air circulation to
cool the heat sink.
•
Locate the refrigerator away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight
may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient
temperatures may also cause the refrigerator not to perform properly.
•
This refrigerator uses thermoelectric refrigeration technology (no compressor) and is not designed for storage in
hot areas like garages, warehouses or outdoors since it is designed to operate at a maximum of 30 degrees
below the ambient temperature.
•
Avoid locating the refrigerator in moist areas.
•
Plug the refrigerator into an exclusive, properly installed-grounded wall outlet. Do not under any circumstances
cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding
should be directed toward a certified electrician or an authorized Products service center.
•
After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before placing food in
the refrigerator compartment.
¾
Electrical Connection
This refrigerator should be properly grounded for your safety. The power cord of this refrigerator is equipped with a
three-prong plug which mates with standard three prong wall outlets to minimize the possibility of electrical shock.
Do not under any circumstances cut or remove the third ground prong from the power cord supplied.
The cord should be secured behind the refrigerator and not left exposed or dangling to prevent accidental injury.
Never unplug the refrigerator by pulling the power cord. Always grip the plug firmly and pull straight out from the
receptacle.
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified electrician or service
technician install an outlet near the appliance.
¾
Reversing the Door Swing of Your Appliance
This unit has the capability of either opening the door from the left or right side. The unit is delivered to you with the
door opening from the left side. Should you desire to reverse the opening direction, please follow the instruction.
Note:
before reversing the door, the power must be shut off. All parts removed must be saved to the
reinstallation of the
door.
This unit has been built with the door hinges on the right. If you wish to change the opening direction, follow the
instructions below:
1. Remove the upper hinge cover (6) first.
2. Remove the three screws (1) that hold the upper hinge (5) (right side) to the frame, take away the upper hinge (5) (right
side).
3. Lift the door and place it on a padded surface to prevent scratching it.
4. Remove the three screws (8) that hold the lower hinge (2) and make sure to remove the lower hinge (2).
5. Remove the left front leg (4) and transfer it to the right side.
6. Remove the whole cover plate (7) at the right side.
7. Before placing the lower hinge (2), remove the bolt pin (9) and reverse the direction of the lower hinge (2). Then install
the lower hinge (2) onto the left side of the lower frame with the three screws.
a
Warning
a
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by an authorized Products service center.
