PARAGON960 X4
14
2.3.1
Monitor Connection
Connect the monitor to the HDMI, VGA or BNC port on the rear panel of the DVR. You can set up
either HDMI port or the VGA port to be the Main monitor output in the OSD settings (see
6.6.1
Monitor OSD
). If you set the HDMI port to be the Main monitor output, the VGA port will be the
Call monitor output, and vice versa. The BNC port will always be the Call monitor. Only the HDMI
video output can deliver full HD resolution (1920 x 1080, progressive, 60 Hz. Vert., 68 KHz hor.), so
if you select VGA output device, resolution selected should be supported by the monitor.
Resolution selected higher than the monitor can support may cause the screen to black out after
rebooting the DVR. Please refer to
6.6.1 Monitor OSD.
BNC Cable
HDMI Cable / VGA Cable
Call Monitor
Main Monitor
Rear View
Figure 2-13
Note:
1.
The connected monitors’ specifications must comply with the resolution requirements.
2.
Do not exceed the max. HDMI cable length of 15 meters. The standard HDMI cables can
support cable length up to 3 meters. For longer distances, such as 15 meters, it is highly
recommended to use high quality HDMI cables.
