LED Indicates Box
PN: 46051EMV402002B
5.
Connection
1
MDVR
External I/O Box
2
3
LED Indicators
Panic Button
4
IR
Receiver
RS-232 Cable
Green
Blue
White
Red
GND
RS232-RX
RS232-TX
DC 5V
1.
Connect to the
RS-232
port on the device (such as MDVR or External
I/O Box) using the supplied
RS-232 Cable
.
2.
LEDs will indicate for notifications.
LED Name
Definition
LED Name
Definition
HDD
(Green)
On: HDD detected
Off: No HDD detected
Flash: HDD is recording
Power
(Green)
On: MDVR power on
Off: MDVR power off
SD
(Green)
On: SD card detected
Off: No SD card detected
Flash: SD card (for event
backup) is recording
Vloss
(Yellow)
On: Video loss
Off: No video loss
GPS
(Green)
On: GPS working
Off: GPS not working
Flash: GPS allocating
ERR
(Red)
On: HDD full, HW error or
system failed
Off: MDVR working normally
WiFi
(Green)
On: WiFi connected
Off: WiFi not connected
Flash: Searching WiFi
HTR
(Red)
On: Heater enabled
Off: Heater disabled
3G/4G
(Green)
On: 3G/4G enabled
Off: 3G/4G disabled
Flash: 3G/4G connecting
ALM
(Red)
On: MDVR Alarm triggered
Off: No alarm from MDVR
Flash: FW upgrading
Note:
If all LEDs are flashing with the buzzer sound, it indicates the box has
received emergent events from the MDVR. To stop the buzzer or get the
LEDs back to the normal state, press the
Panic
button for 3 seconds.
3.
Press the
Panic
button when under an emergency situation.
Press once for sending emergent events: Press the button will send an
emergent event to DVR and then DVR will transfer the emergent
event data to the connected Control Center (Xfleet).
Press for 3 seconds to stop buzzer: When the box receives emergent
events sent from the MDVR, the buzzer will sound for 30 seconds.
Users can press the button for 3 seconds to stop the buzzer.
4.
For controlling the MDVR using the IR remote control of the MDVR.
