eNVP-JNN-IV-D0008 / eNVP-JTX-IV-D0008 / eNVP-JNX-IV-D0008
7
2.
Connection and Installation
2.1
SSD Installation
Users can install up to two 2.5” SSD into the AI NVR for recording. Please follow the steps below
to install the SSD.
Note:
The AI NVR does not support hot swap for the SSD. Ensure to power off the device
before removing the SSD. Also ensure to remove the SSD only after the power was
completely shut off. This would protect and extend the operating life of the SSD.
1.
Make sure the AI NVR is powered-off. Unlock the SSD Tray (turn clockwise) using the
supplied
SSD Lock Key
.
Lock
Unlock
2.
To install the SSD, pull the
Release Latch
to open the
SSD Tray Arm
.
Release Latch SSD Tray Arm
Chapter
2
