eIVP-CML-AI-D0000 AI Box
12
3.3
Onboard Headers and Connectors
Please note that the onboard headers and connectors are
NOT
jumpers. Do NOT place jumper
caps over these headers and connectors, otherwise, it will cause permanent damage to the
motherboard.
CPU Fan Connectors (CPU_FAN1)
The motherboard provides a 4-Pin CPU fan
(Quiet Fan) connector. If you plan to connect a
3-Pin CPU fan, please connect it to Pin 1-3.
Refer to
No.2
in
3.1 Motherboard Layout
.
ROM Recovery Header (ROM_R)
Thus header allows qualified technicians to
reload firmware into the SPI boot flash in case
there is problem with the data.
Refer to
No.5
in
3.1 Motherboard Layout
.
2.5W Audio Amp Output Header (MONO1)
Please connect the chassis speaker to this
header.
Refer to
No.3
in
3.1 Motherboard Layout
.
Chassis Intrusion Header (CI1)
The motherboard supports Case Open
detection feature that detects if the chassis
cover has been removed. This feature requires
a chassis with chassis intrusion detection
design.
Refer to
No.7
in
3.1 Motherboard Layout
.
Serial ATA3 Connector (SATA0)
The SATA3 connector supports SATA data
cables for internal storage devices with up to
6.0 Gb/s data transfer rate.
Refer to
No.4
in
3.1 Motherboard Layout
.
Serial Port Header (COM1)
The COM1 header supports a serial port
module.
Refer to
No.8
in
3.1 Motherboard Layout
.
