6
Note:
Make sure that the connected monitor or other video device input is terminated
with 75 Ohm.
Connecting a BNC video cable at this output switches off the internal 75 Ohm
termination!
14 Alarm Out:
N.C / N.O relay output. (ECOR264-4: 1 x , ECOR264-9/16: 4x)
15
Audio Out:
Audio output, RCA socket, line audio signal 1V max at 10 KOhm
.
.
1.6
VIDEO INPUTS/OUTPUTS INSTALLATION
Camera and CCTV monitor must use 75 Ohm video cable (e.g. RG-59, RG-6, RG-11) with BNC
connectors.
To avoid impedance mismatch and undesired loss/reflections, 50 Ohm coax cable (e.g. RG-58), antenna
cable and other types of coaxial cable are not compatible.
All connected video sources must provide a 1 Vpp NTSC or PAL standard video signal.
When converting transmission lines (twisted pair, fiber optics, radio) to the video inputs, be sure to verify
accurate receiver calibration
and signal levels.
ATTENTION:
In order for the system to auto-detect the appropriate video format (NTSC or PAL), make
sure that there is a video signal on video input 1 upon power-up.
The "Out" BNC sockets allow to loop the video input signal to additional video devices.
Note:
Make sure that the connected monitor or other video device input is terminated with 75 Ohm.
Connecting a BNC video cable at this output switches off the internal 75 Ohm termination!
Summary of Contents for ECOR 264x1-16
Page 101: ...95 To assign a fixed IP address in Windows 2000 XP ...
Page 102: ...96 ...
