20
Figure 5-16
Figure 5-17
5.3 Start-up debugging
(1)
checking whether the input voltage is the rated input voltage
(2)
connecting the resistance wire load (bulb) to output switch
(3)
closing the input switch, auxiliary switch (two switches) and output switch in proper order.
(4)
rotating the rotary switch ON/OFF on the door to “ON” and the touch panel would bright.
(5)
Entering the setting screen, setting the charging voltage of the first step as 10%
、
50%
、
100%
rated voltage in turn and it begins charging. Checking whether the virtual voltage is in line with
the setting voltage or not. If it matches, then go to the next step.
(6)
Closing the output switch, ON/OFF rotary switch, auxiliary switch (two switches) and input
switch in order. Switching off the resistance wire load and connecting the battery to the output
terminal of charger.
(7)
After making sure the battery connects correctly, closing the input switch, auxiliary switch
(two switches), output switch, rotary switch (rotating to “ON”) in order. Establishing the
