11
WWW.EVERETIMAGING.COM
IR REMOTE CONTROLLER
POWER
By pressing the POWER key when the camera
is on, the camera will rotate and go in the
‘stand
-
by’ mode.
When the camera is in stand-
by mode and you Press the power button
again, the camera will boot and automatically
go back to the Default PTZ position. The
Default PTZ position is the PTZ position of the
camera when you turn it on for the first time.
The only preset that overrules this Default PTZ
position when the camera is rebooted, is the
‘0’ Preset.
You can always go back to the
Default PTZ position by pressing the OK
button.
NOTE: The above is only applicable when
solemnly IR remote control is used to control
PTZ camera. In situations where the EVKB-100
is used to control the camera Preset ‘1’ will
overrule the HOME position.
FREEZE
（
Not Supported in USB
）
Short press FREEZE key to freeze/ unfreeze the
image.
IRT (IR Transfer/IR Pass)
Open / close the IR pass function. Once press
the IRT key, the camera will receive and
Pass the IR remote control signal to the
codec/terminal (via VISCA IN port).
