51
Expand
This function is used to set the internal test
signal: Gray scale 1, Gray scale 2, Gray scale
3, Gray scale 4, Color bar, Red, Green, Blue,
Cross hatch, White, Black and Raster gray.
When you get into the Test Pattern mode,
press MENU to get back the selection page of
Test Pattern.
Test Pattern
Expend
Language
Auto setup
Keystone
Logo
Security
Power management
Filter counter
Test pattern
Network
Factory default
Lamp counter reset
Test Pattern
Function : PC controls projector via LAN.
Preparation:
1. Equipments: PC, projector, cables
2. Connection procedures:
Connect the projector to routers or switches of the LAN by direct or cross cable. If it fails to
connect PC and projector by parallel cable, please switch to cross cable as suggested.
3. After the computer is booted and the projector is plugged in, indicator lights of LAN interface
RQZLOOÀDVKFRQWLQXRXVO\
Network
Operation procedures:
1 Turn on the projector.
2 Obtain network address. DHCP set is
displayed as On and obtain network address
automatically.( If familiar with network, you
can set DHCP as Off and obtain network
address manually.)
3 Enter network settings menu.
Expend
Language
Auto setup
Keystone
Logo
Security
Power management
Filter counter
Test pattern
Network
Factory default
Lamp counter reset
(1) Press MENU button on the remote control to
display screen menu. Press
ST
button to
select Expand, then press the OK button.
(2) Press
ST
button to select Network, and
then press the OK button to enter the network
menu.
MAC address ... Displays the MAC address
of wired network of this
projector.
IP address .........Displays the IP address of
wired network of this
projector.
ENTER
Network setting
DHCP
On
Set
Cancel
IP address
Subnet
Gateway
DNS
Adjust Select Back
LAN
Esc