HEAT LIVE RELAX
OPERATING INSTRUCTIONS
Please Note: If the thermostat is set to a lower temperature than the ambient temperature, the unit will not run.
THERMOSTAT CONTROL KNOB
The appliance has an inbuilt thermostat which allows you to set the maximum temperature of the room. Rotate the
Thermostat Control Knob fully anti-clockwise to set to the lowest setting. Rotate clockwise to increase the thermostat
temperature setting. While the appliance senses an ambient temperature lower than the set temperature, it will run.
When the ambient temperature reaches the set temperature, the elements will shut down, and will not restart until
the ambient temperature drops sufficiently.
To set the temperature:
1.
Turn the thermostat control knob clockwise until the maximum temperature setting is reached.
2.
Once the desired ambient temperature has been reached, very slowly turn the thermostat control knob
anti-clockwise until there is an auditable click. The thermostat has turned off and the elements will stop
producing heat.
3.
The heater elements and fan will now turn off and on automatically, maintaining the room temperature you
have set. To increase or reduce this temperature, the thermostat knob should be adjusted accordingly.
FUNCTION SELECT KNOB
Make sure the power supply is on. There are five settings: Off, Low power, Low power with oscillation. High power
& High power with oscillation.
Off: When the Setting knob is set to “Off”, the appliance will not run.
Low Power: When the Setting knob is set to “Low Power”, only a section of the element will run (1400W) with the
fan.
Low Power with Oscillation: The appliance will run as per the “Low Power” setting, with the appliance body
oscillating on its base.
High Power: When the Setting knob is set to “High Power”, the whole element will run (2400W) with the fan.
High Power with Oscillation: The appliance will run as per the “High Power” setting, with the appliance body
oscillating on its base.
SAFETY FEATURES
1. A thermal overload protector is built in to prevent overheating.
2. When an overheat temperature is reached, the heater will automatically shut off. It can only resume operation
when the user resets the unit (see reset instructions below).
To reset your heater:
1.
Unplug the heater and wait between 5-10 minutes for the unit to cool down.
2.
Then, turn on the unit again and operate normally.
A tilt switch is built into the unit. If tipped over the appliance will shut off. Right the appliance to restart.
