Presets - 5 On Board, 127 Via MIDI
NOTE: SWIRL status is saved with the preset.
Save Mode times out after a few seconds.
Pressing either Footswitch exits Save Mode.
Load Presets
Save Presets
The currently loaded Preset is indicated on the Preset LED Ladder. When a Preset is modified the Preset LED
blinks once.
When a Preset is loaded or when toggling between Parameters using , Knob positions will not align with their
current Parameter values. As a result, turning a knob will likely cause an abrupt change in the sound.
With Catch Up ON, the sound does not change until the Knob is moved to the position corresponding to the
current value. The LED Ladder indicates whether the knob must be turned CCW (top LED blinks) or CW (bottom
LED blinks). The LED flashes more rapidly as the knob approaches the value set by the Preset. All five LEDs blink
once when the knob matches the stored Parameter value.
NOTE: To enable/disable Catch Up Knob Function, power up in System Setup mode and press SWIRL
Footswitch to toggle ON/OFF.
Catch Up Knob Function
To select and load a Preset using Footswitches:
1. SWIRL Footswitch selects Preset 1 to 5.
Preset 1 (top LED) to Preset 5 (bottom LED)
blinks.
2. ACTIVE Footswitch loads the Preset. LED stops
blinking.
To save one of the 5 Presets using the Buttons:
1. Press & hold SWIRL Button
-
Blinking Ladder and Button LEDs let you know
you have entered Save Mode.
2. SWIRL Button selects Preset 1 to Preset 5.
3. ACTIVE Button saves Preset
- LEDs stop blinking to let you know the Preset
is saved.
NOTE: To select Preset, SWIRL Footswitch must be
in Preset mode. If SWIRL LED is lit, press and hold
SWIRL Footswitch.
