www.event-lighting.com.au
1
Safety Instructions
Warning
•
Do not open this device, there are no user serviceable parts inside. Risk of electric
shock.
•
Do not look directly at the light source from close range.
•
Avoid contact with the unit during operation, as the housing may become hot. Allow the
fixture to cool for at least 15 minutes after turning off before touching.
•
Install this device in a location with adequate ventilation, at least 50cm from adjacent
surfaces.
•
Do not operate this device, or connect this device to power, within 50cm of any
flammable material.
•
Use a safety chain when mounting this device overhead.
•
Do not operate this device outdoors where excessive dust, heat, water, or humidity may
affect it.
•
Do not operate this device if the housing, lenses, or cables appear damaged.
•
Do not connect this device to a dimmer or rheostat.
•
Do not operate this device at temperatures higher than 40
°
C (104
°
F).
•
Only
connect this device to a grounded and protected circuit.
•
Only
use the hanging bracket to carry this device.
•
Stop using this device immediately if a serious operating problem becomes apparent.
Fuse Replacement
If the fine-wire fuse of the device fuses, replace the fuse with one of the same type of rating.
Before replacing the fuse, unplug the device from the power source.
Fuse Replacement Steps
1.
Unscrew the fuse holder located on the rear panel from the housing.
2.
Remove the old fuse from the holder.
3.
Install the new fuse into the holder.
4.
Place the fuse holder back into the housing and secure tightly.
Product Installation
PAR12X8L can be mounted in many orientations, provided each individual device is secured by
the use of the correct mounting bracket. Use a safety chain when mounting PAR9X15O
overhead.
