www.event-lighting.com.au
2
Safety Instructions
Warning
1.
It is recommended that two people lift each CB1 Crowd Barrier into place. Please
observe your local occupational health and safety guidelines.
2.
It is recommended that at least three units are used together, as the units lock together
using latches and bolts. A single unit on its own will not be effective and runs the risk of
collapse.
3.
In order to set up an effective crowd barrier, these instructions relating to latching the
units together must be followed, to avoid the risk of collapse or gaps forming between
pieces, that may result in injury.
4.
In situations where a high number of people may be present, it is recommended that
there is crowd control employed, to avoid the risk of excessive force being placed on the
crowd barrier.
5.
The CB1 crowd barrier should only be used on a flat surface.
Unpacking
Each CB1 Crowd Barrier comes with a bolt, that is used to secure one unit to the next and lock
the upright into place. Upon unpacking, this bolt is in a zip lock bag, attached to the frame of the
crowd barrier.
Set Up
1.
Place the first flattened unit on flat surface, with the sloped
front facing in the direction that the crowd will be.
2.
Lift the wall, which has the curved top, from the end of the
sloped front, towards an upright position. The smaller frame,
hinged to the wall, should fall in place as the wall is raised,
resting behind the crowd facing side of the wall. By pushing
near the bottom of the wall from behind, be sure that the wall
is as close to the platform as possible.
Note: To prevent movement while
setting up, place the provided bolt
partially through the hole in the
wall frame, so it makes contact
with the floor frame. Later, this
bolt will be pushed into the next
adjoining unit.
