Even-GLO™ Series GA301
Page 41
October-28-15
Maintenance & Troubleshooting Instructions
Maintenance instructions for models GA301-M & GA301-MP:
Maintenance
∗
Follow Caution and General Safety rules at all times before / during use.
∗
Before performing ANY service to the heater, shut off the gas supply,
disconnect the regulator from the LP-Gas Cylinder and remove the battery from the
ignitor module.
∗
If any maintenance issues are found place the heater OUT OF SERVICE until
it has been repaired by a certified service person.
Use only manufacturer
recommended replacement parts.
Daily Inspections:
3.
Keep the appliance area clean and free from combustible materials, gasoline and
other flammable vapors and liquids.
4.
The visible portion of the Gas Hose must be visually inspected before each use. If
there is evidence of excessive abrasion or wear, or if the hose is damaged the
hose assembly must be replaced prior to the
appliance being put into operation.
5.
Keep the ventilation opening(s) free and clear from
debris and cobwebs.
6.
Visually check the Burner flame pattern during use.
A “
Proper Flame
” should resemble image on right.
7.
If at any time flames extend beyond the emitter
surface (see image to the right below “
Improper
Flame
”) or black soot is found on the inside of the
reflector
TURN OFF
the heater immediately and place
OUT OF SERVICE
until
repairs are made.
8.
Clean the appliance, if necessary, with non-
combustible and non-corrosive cleaning agents.
Ensure control compartment (ignition module),
burners & circulating air passageways are kept
clean of dust, insects, cobwebs and other debris.
Annual Inspections:
1.
Inspect and Leak Test entire Gas Hose Assembly
for damage, excessive abrasion , wear and leaks:
a.
Ensure burner is cool to touch and supported while disassembling.
b.
Disassemble the Burner from the Pole by removing the four (4) screws in the
Pole Neck.
