Save these instructions for future reference
2. Place the baby bottle or jar into bottle rack.
3. Plug the power cord into your socket at home and make sure the wall switch is turned on.
4. Press the knob on the bottle warmer , the red light will illuminate and heating process will start.
5. The heating cycle is completed once the warmer stops and the red light turns off.
6. Remove the bottle or jar from the bottle warmer and stir or shake. Always check the temperature of the milk or
food before feeding your baby.
7. Unplug the bottle warmer from the main supply, pour the water away and leave it to cool down before cleaning.
CLEANING AND MAINTENANCE:
• After unplugging form the electricity supply and allowing to cool down, the bottle warmer can be wiped clean and
dried with a clean nonabrasive cloth.
• Scale residues may be found on the heater plate. These residues can be removed by using a dilute solution of 1 part
vinegar to 2 part water. Pour the solution into the heater tray and leave for an hour, rinse off and dry well. Such
cleaning is required, since the scale residues can diminish the bottle warmer efficiency.
Save these instructions for future reference
WARNINGS:
This appliance is not intended to be used by children, people with reduced physical sensory or mental capabilities,
or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of
the appliance by a person responsible for their safety.
1. Before using the product, make sure the warmer and its accessories (including the main cable) do not have any
visible damage.
2. Keep out of the reach of children.
3. Never use the warmer without water.
4. Never use more than 20 ml of tap water in the bottle warmer. Use the recommended quantity of water
mentioned in the reference table to prevent overheating or inefficiency in the product.
5. Place the warmer on a firm, even surface.
6. Never immerse the bottle warmer in water.
7. Careful, when in use the bottle warmer contains hot water.
8. Always unplug the warmer from the electricity supply when not in use.
CAUTION:
The power-supply cord can't be replaced. If damaged, the product should be disposed.
IMPORTANT:
To prevent milk overheating, do not allow warming for over 15 minutes.
Always shake the bottle and check the temperature of the milk or food before feeding the baby.
USAGE INSTRUCTIONS:
1. Add tap water in the bottle warmer as indicated in the following table:
Important: This information is just for reference, the final temperature may vary depending on the material and
thickness of the baby bottle.
Milk Bottle
120 ml (4 oz)
180 ml (6 oz)
210 ml (7 oz)
240 ml (8 oz)
120 ml (4 oz)
180 ml (6 oz)
210 ml (7 oz)
240 ml (8 oz)
9 ml
10 ml
10 ml
10 ml
14 ml
15 ml
16 ml
16 ml
Inicial
Temperature
Room Temperature (27 °C)
Room Temperature (27 °C)
Room Temperature (27 °C)
Room Temperature (27 °C)
Cold (5 °C)
Cold (5 °C)
Cold (5 °C)
Cold (5 °C)
Water
needed
Heat
Time (±15 sec)
1 mins 45 secs
2 mins
2 mins
2 mins 30 secs
2 mins 45 secs
3 mins
3 mins 15 secs
3 mins 30 secs
Final
Temperature
(±3 °C)
37 °C
37 °C
37 °C
37 °C
37 °C
37 °C
37 °C
37 °C
Summary of Contents for 8754
Page 5: ......
