2
INSTALLATION OF CONTROLS AND SPEED SENSOR
First remove the original equipment from left side of the handlebar. Grip, the brake lever and shifter. In reverse
order mount LCD display, LCD controller, accelerator, brake lever and grip. LCD controller and accelerator can be
optionally installed on the right side of the handlebar.
brake lever
grip
handlebar
LCD controller
LCD display
LCD display holder
brake lever
right side
After installing all controls, connect their connectors to the main harness.
Fasten Speed Sensor to the frame of the rear fork in an appropriate place so between the sensor and the magnet is
not a distance greater than 5 mm. Now install the magnet on the spoke and set it, his magnetic side,
to the sensor. Check, that the distance is 5 mm. If the sensor and magnet are installed correctly, when rotating the
LED on the sensor is activated and flashes when passing through the magnet.
Connect controlers to the main harness
and then connect the connector from
motor unit.
accelerator
www.EVBIKE.cz
Importer:
GWL Power Ltd., EU-VAT ID: CZ682998344
