EvaKool DOWN UNDER II Series, Instruction Manual

Page: 7 / 28

7
DOWN UNDER
SERIES II
AMB/Ambient Temperature:
This indicates the ambient temperature inside the motor
compartment of the fridge.
Bluetooth:
The bluetooth symbol will turn on and make an audible beep when you have
successfully connected to the app. This symbol will not be illuminated unless you have
successfully connected. There is no setting within the fridge that turns the bluetooth on or
off.
Voltage Indicator:
When running your fridge on 12V this indicates the voltage at the fridge
(not at your battery). The voltage indicator on the fridge will typically be different to the
reading at the battery. This is because there can be voltage drop present between your
fridge and battery. This can be to do with the length and quality of your power cord, and
also be influenced by the health/life of your battery. When the fridge cycles on, the voltage
will typically drop and then increase again when the fridge cycles off. This feature is useful
for identifying any fridge errors (such as an E1).
When running your fridge on the supplied EvaPower 240V adaptor the voltage indicator
will read approximately 14.5V, as this is the rated output of the 240V adaptor.
Battery Charge:
When running the fridge on 12V, this icon will indicate how much battery
charge you have left. Just like the voltage indicator reading, the battery charge reading will
typically drop when the fridge cycles on, and will increase again when the fridge cycles off.
If you notice the battery symbol on your fridge getting low, we recommend checking your
battery voltage and putting it on charge if possible to prevent any power issues to your
fridge.
When running your fridge on 240V the battery charge will indicate it’s full.
4.2 Display Panel Settings
To turn on/off the refrigerator:
• Hold the button for three seconds.
• The fridge will make an audible beep and turn on.
Setting the temperature:
• To set the large bin press the button once.
• To set the small/stepped bin press the button twice.
• Once the selected room is flashing use the or buttons to select the desired
temperature. Temperature recommendations can be found on page 9.
• Once the desired temperature is selected, it will flash several times, and after a few
seconds the temperature will automatically set.