Installation of the Defender Wireless Alarm
1.
Check the contents of the box carefully.
2.
The units should be sited in accordance to your
Risk Assessment
.
3.
Remove the battery clip from the power pack the battery pack can now be
removed from the backplate by releasing the Reusable Cable tie (as per
image below). The back tray has four pre drilled mounting points for you
to mount the unit to the wall, post etc
4.
Fix the unit to the wall making sure the siren is at the bottom. Now refit
the Battery pack using the resettable cable tie supplied.
5.
Push fit the pp3 style battery clip onto the battery pack (the clip will only
fit one way)
6.
Plug in the white four way connector block from the front cover to the
base plate making sure that all screws are facing the same direction.
7.
Fix the front cover to the backplate and secure the front panel using the
two chrome screws, one at the top and one at the bottom.
8.
Switch the unit on using the on/off rocker switch, the single LED will now
glow green to indicate the battery is in good condition, the unit is now
ready in Standby mode.
Should you require assistance with the configuration or installation of the
units, please call the “Evacuator helpline” on 0845 130 7258 during office
hours.
Push Button Control Panel
The Units have three Push Buttons. Main Activation, Reset and Test. We also have a
master on/off switch along with one “battery test LED”
