Introduction:
The ZW47 is a Z-Wave enabled device and is fully compatible with any Z-Wave Plus enabled network.
around obstacles and radio dead spots to ensure that the signal is received at its intended destination.
ZW47 is a security enabled Z-Wave plus device. A security Enabled Z-Wave Plus Controller must be used in order to fully utilize the product.
Key Features:
---Remote ON/OFF control via the Z-Wave controller
---Manual ON/OFF control with the front panel push button
---Support Association Group and Auto Report switch status
---Support 5V 2A USB Charging
---Support Z-Wave Range Test Tool
---Support firmware upgrades via Over-the-air (need Gateways support)
Product Overview:
A Z-Wave controlled outlet-1
B Z-Wave controlled outlet-2
C ON/OFF PROG Button
D USB Charging 5V 2A
E AC plug
F RGB LED Indicate
Key Function Description
Function 1: Press button one times to turn the outlet1 ON or OFF
Function 2: Press button two times quickly to turn the outlet2 ON or OFF
Function 3: Press and hold button for 2 seconds to turn the outlett1and Outlet2 ON or OFF
Function 4: Press button three times quickly to ADD and REMOVE
Function 5: Press and hold button for 6-8 seconds to Z-Wave Range test tool
Function 6: Press the button twice quickly and then press and hold the button 10S.device will reset
(Node:Please use this procedure only when the network primary controller is missing or otherwise inoperable)
Function 7: Press button six times quickly to Change Parameter 17 Value(circulate)
LED Indicate Description
1:LED Indicate Power Meter
White = Plug is off
Dark Blue = 0 – 300 W
Each module is designed to act as a repeater,which will re-transmit a radio frequency (RF) signal by routing the signal
A
E
D
C
B
F
Dark Blue = 0 – 300 W
Cyan = 300 – 600 W
Green = 600 – 900 W
Orange = 900 – 1200 W
Red = 1200 – 1500 W
Purple = 1500 – 1800 W
Purple blink = over 1800 W
2:LED Indicate Z-Wave Range Test Tool
Solid Green = direct communication with the primary controller is stable
Flashing green = direct communication with the primary controller,but the signal is not good
Solid orange = communication with the primary controller via repeater nodes,the signal is stable
Flashing orange = communication with the primary controller via repeater nodes,but the signal is not good
Solid red = communication with the primary controller has failed
Z-Wave Remote Control
ADD or Remove the ZW47 from the existing Z-Wave home control network with your primary controller.
---Refer to your primary controller instructions to process the inclusion / exclusion setup procedure.
Include ZW47 to/from a Z-Wave Gateway with supporting Security.The ZW47 can support the Primary Controller that implemented the security S2.
Notice: Including a node ID allocated by Z-WaveTM Controller means “Add” or “Inclusion”. Excluding a node ID allocated by
Z-WaveTM Controller means “Remove” or “Exclusion”.
Z-Wave MULTI_CHANNEL
ZW47 is multi channel device，It has three endpoints. Outlet-1 is Endpoint1, outlet-2 is Endpoint2. USB is Endpont3.
ZW47 Endpoint1 / Endpoint2 Device Type
Generic Device Class: GENERIC_TYPE_SWITCH_BINARY
Specific Device Class: SPECIFIC_TYPE_POWER_SWITCH_BINARY
---When prompted by your primary controller, click the PROG button Three times in one second.
