EMERGENCY CHARGING PROCEDURE
BATTERY CHARGING AND CARE
The scooter comes with an emergency charging cable.
If the scooter is folded up and the battery is
completely flat, then the standard charging socket
can be difficult to access. In this instance, the
emergency charging cable can be installed to allow
the battery to be charged while the scooter is folded.
The emergency charging cable is shown below:
To install the charging cable, plug this in to connector
cable at the front of the underside of the scooter
(as shown below).
Install the cable, then proceed to charge the battery
as described in the next section.
Step 1. Insert the charger in to the power outlet and
switch the power on. Ensure the charger is not
connected to the scooter, and one of the charger
LEDs is lit green.
Step 2. Insert the round plug on the charger in to the
charging port of the scooter (arrow below). The LED
should change from green to red. The LED will
change back from red to green when charging is
completed.
The scooter should be left on charge until the battery
is fully recharged. A full recharge takes around 5
hours. The status of the charge is shown by the LED
lights on the charger, and is described below:
Status
Power LED Status LED
Standby or Charging
Complete
RED
GREEN
Charging in progress
RED
RED
Over current/voltage/
Temperature, or other
fault status
RED
Flashing
RED and
GREEN
Ensure that the charger is removed from
the power outlet and the scooter after
charging. Failure to do this may flatten
the battery. Do not remove the battery
pack while the scooter is switched on.
