23
TROUBLESHOOTING:
Before any service is done that would require opening the unit it must
be disconnected from the power source. If your location has lockout-tag out
protocols, please follow them.
System will not turn on:
1)
Make
sure
power
cord
is
properly
plugged
in.
2)
Make
sure
the
power
switch
on
the
back
of
the
unit
is
turned
in
the
“ON”
position.
3)
Before
Checking
the
circuit
breaker
located
in
the
Prodigy,
disconnect
the
supply
power
to
the
unit
by
unplugging
power
cord.
Gas is not being delivered to the cage or the flow rate is not correct:
1)
Check
that
your
gas
supply
has
not
run
out.
2)
Check
that
the
CO
2
tank
valve
is
fully
open.
3)
Check
that
the
connections
from
the
gas
supply
regulator
to
the
Prodigy
CO
2
input
is
properly
mated.
4)
Check
that
the
gas
output
hose
on
the
right
side
of
the
Prodigy
is
connected
to
the
cage
input
fitting.
If
unit
was
operated
without
hoses
connected
the
safety
valve
would
have
opened.
You
will
hear
gas
being
released
inside
the
unit.
Check
again
that
all
hoses
from
the
Prodigy
that
you
are
going
to
use
in
the
cycle
must
be
connected
to
the
lid/lids.
Restart
unit
and
run
cycle
again.
5)
Check
that
the
regulator
is
open
and
set
to
20
PSI.
6)
Check
that
the
electric
heater,
inline
from
the
gas
supply
to
the
regulator,
is
operating.
The
heater
runs
intermittently,
switching
on
when
heat
is
required.
If
the
gas
is
not
adequately
heated,
it
will
not
flow
properly.
7)
Safety
Pop
‐
off
may
have
malfunctioned,
follow
these
steps.
a.
Remove
the
front
plate.
Take
out
the
4
screws
that
secure
the
plate
to
the
body.
Be
careful