EUTECH INSTRUMENTS alpha-pH 2000D, Instruction Manual, Page: 49 / 50

Instruction Manual
α
lpha-pH2000D
- 44 -
11.5 Appendix 5 – Abbreviations used in menu displays
Abbreviation Meaning Abbreviation Meaning
MEAS Measurement CUR. 1 Output current 1
CAL Calibration CUR. 2 Output current 2
ENT Enter OUT Output signal
OFS Offset 4 - 20 4 to 20mA
C. CD Calibration security code 0 - 20 0 to 20 mA
S. CD Setup security code R.0 Value at 0 mA
SET Setting R. 4 Value at 4 mA
ATC Automatic temperature calibration R. 20 Value at 20 mA
SP1 Set point 1 CU22 Out of range output current 22 mA
SP2 Set point 2 WASH Wash
LO Low limit H. INT Cleaning interval in hours
HI High limit S. DUR Cleaning duration in seconds
HYS Hysteresis CNFG Configuration
ON. D On delay BKLT Back light
OFF. D Off delay LEVL Level
CNTR Controller PH SY Symmetrical pH mode
L. CT Limit control ORP SY Symmetrical ORP mode
PLC Pulse length control AL. D Alarm delay
PFC Pulse frequency control AL.C Alarm Contact
P/PI Proportional control STDY Steady
EN Energized FLET Fleet, impulse
DEEN Deenergized DEF Default
REL Relay FCT DEF Factory default
PRP Proportional band CAL DEF Calibration default
T. PL Pulse length time
F. PF Pulse frequency
IAT Integral action time
MANU Manual