6
3. Operating the Controller
The Main Display
Press
MODE
key to switch to three
main displays - the Conductivity
display, the temperature display
and “
SEt
” display.
Press
MODE
key once to get into
the temperature measurement.
The
°
C annunciator lights up when
you are measuring temperature.
The display shows current
measured temperature (with ATC)
or the temperature that was set in
MTC mode. Press
MODE
key
again and the display toggles to
the
“SEt”
for SETUP menu.
Press
ENTER
key to go into the lower-level setup menus while
the display shows "
SEt
". These lower-level menus allow
calibration of Conductivity, Temperature and other parameters
including set password, Hi or Lo Setpoints, Hi and Lo Hysteresis
values and temperature coefficient.
uS/mS
MODE
ENTER
7.4
o
C
MODE
ENTER
24.0
SETUP
MODE
ENTER
SEt
Summary of Contents for ALPHA CON 100 - REV 1.1
Page 29: ...26 NOTES ...
Page 30: ......
