8
English
RELEASING THE BRAKES
To make it possible to transport the wheelchair with the electronics switched off, the brakes/motors
must be disconnected. This is done by switching off the electronics and raising the red lever by the
chassis leg adjacent to the rear swivel wheel. The chair can now be transported without the mo-
tors braking. To return to driving, lower the red lever and start the electronics. If the electronics are
started while the brakes are disconnected, it will give an error message on the control box. Switch off
the electronics, connect the brakes and restart the chair, and the error message will disappear.
RISK OF INJURY!
NOTE! Make sure the wheelchair is on level ground when the brakes are disconnected.
Otherwise, the wheelchair can roll away without control.
TRANSPORT
When transporting the chair in motor vehicles, it is important that the brakes be connected. See the
section above. The chair should be strapped in place with straps. Separate attachment loops are
available as accessories, which can be installed on the wheelchair and to which the straps can be
fastened. The wheelchair is not designed so the user can sit in the chair during transport. By remov-
ing the back support, armrests and footrest, the transport size can be reduced. The batteries in the
wheelchair are sealed and are the GEL type; they are also approved for transport by air.
