Eurotech PCN-1001, User Manual

Page: 76 / 118

Know WinClient PCN-1001 User manual
76
PCN-1001_UserMan_En_4.0
The following commands can be used to manage the system diagnostic:
COMMAND
DESCRIPTION
diagnostic_en 1 (unsigned char)
Diagnostic enabled (default configuration)
diagnostic_en 0
Diagnostic disabled
pcn1001_status
Returns the diagnostic status displaying two values (unsigned char)
The first value will indicate the diagnose status:
• If it is 1 the diagnose is positive (no problems occurred)
• If it is 0 the diagnose is negative (there is a problem)
The second value indicates the error code (it is 0 if the diagnostic is positive)
Note:
All the commands listed in the table above are also available for the RS485_GUI except for the
“pcn1001_status” command that returns the diagnose status without the error code.
“Use Move detection” panel
“Use Move detection” is an algorithm that when enabled enhances the detection sensitivity.
Note:
It is suggested that this feature is kept as enabled.
The colour of the grey circle will change in the following way:
• The circle should appear green when somebody is crossing the detection area
• The circle should appear red in other cases.
The following commands can be used to manage the Move Detection:
COMMAND
DESCRIPTION
move_det_en 1 (unsigned char) Move detection enabled
move_det_en 0 (unsigned char)
Move detection disabled
move_det_val Returns the current value of the “Move detection” parameter.
Two values (int) will be returned, one for the right sensor and one for the left
sensor.
The final value should be the average between the right and left sensors
move_det_thr
Used to set the threshold value. Use the “Move_det_thr” followed by the
value of the new threshold (int)
move_det_status
Returns the current move detection status displaying a value (unsigned
char) that can be:
0 if the counting is disabled
1 if the counting is enabled because the “move detection” algorithm is
disabled or because there is a cross through the gate