CUSTOMER CARE CENTER 800.898.1879 www.eurotechappliances.com
7. Turn on water supply.
Check for leaks at water faucet and
machine before proceeding. Be sure the
water taps are on before starting.
8. Prepare Washer/
Dryer for Use
Before using washer/dryer, read owner’s
manual thoroughly. Save all instructions
for future reference.
Wipe inside and outside of washer/dryer with a damp cloth before running to
remove any dust or debris.
Run your empty washer/dryer through a complete wash cycle before washing
clothes. Check for water leaks and proper operation during this
test run.
Eurotech denies all liability if instructions are not followed correctly.
. Water Drainage
Water may be drained into a sink, drainpipe or standpipe. To prevent
siphoning, do not seal drain hose into drain outlet.
Wall or Floor Standpipe Drain System - The top of the standpipe must be
between 23” (60 cm) - 35” (90 cm) from the bottom of the washer.
You should securely attach drain hose to keep water pressure from allowing
hose to come loose and leak on the floor.
5. Level Washer/Dryer
The front and rear legs may be screwed /unscrewed to level the machine.
To access legs, tilt machine backwards until it rests against wall or other
stable structure. Adjust legs up or down until washer is stable and does
not rock front-to-back or side-to-side when upright. Once machine is level,
tighten locknuts.
IMPORTANT:
For best performance,
washer/dryer
must rest solidly
on a sturdy floor
or platform, with
minimum vibration.
6. Connect to electric power
Plug power cord into grounded outlet only (see Grounding Instructions on
page 3 for complete details). Be sure power is OFF at fuse box/circuit
breaker before plugging in machine for the first time. Plug cord into outlet
and turn power on at circuit breaker.
NOTE: Remove four
() shipping bolts
prior to plugging
machine into
electrical outlet.
Do not cut power
supply cord!
Installation Instructions
5
MIN. 60 C
M
MAX.90 C
M
A
