SPECIFICATIONS ///
Camera (Transmitter)
TV System PAL standard
Integrated Lens 5.6mm, F2.0 fixed focus
Resolution 360 horizontal TV lines
Signal/Noise Ratio
48db
High-Speed Electronic Shutter
1/60 - 1/15,000 sec
Image Sensor 1/3” CMOS
Min. Illumination
0.1 lux
Current Consumption
120mA
Overall Size
3.25” W x 7.3” H x 4.5” D
Case Finish
UV resistant ABS plastic,
suited for indoor or outdoor use
Frequency Range
2.41 - 2.47 GHz
Modulation
FM
Video Signal/Noise Ratio
48db
Audio Signal/Noise Ratio
45db
Channel Selection
Electronic tuning with PLL
Optional
Battery
Camera - 5 x AA (not supplied)
General
Operating temperature
-10
°
C to 40
°
C
14
°
F to 104
°
F
Humidity
Less than 85%
APPROVALS ///
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
CE directive 93/68/EEC, EMC directive 89/336/EEC, LV directive 73/23/EEC.
This class B digital apparatus complies with Canadian ICES-003.
WARRANTY ///
This product has a one year manufacturer’s warranty which covers parts and labor only. In the unlikely
event that you encounter a technical or quality issue, please contact Xanboo at 1.877.926.2661.
Xanboo will replace defective units within the warranty period.
3
4
MOTION-SENSING CAMERAS ///
21ST™ Cameras are equipped with a motion sensor or PIR. When a Camera detects motion, a red
light flashes on the Camera and an audio alert sounds on the Monitor. The volume control for the alert
is on the rear of the Monitor.
MULTI-CAMERA OPERATION ///
The 21ST
™
Wireless Camera System
is designed to work with up to (3) Cameras. Additional
Cameras are sold separately (ET-C500).
IMPORTANT:
When using more than one Camera, make sure
each Camera is assigned to a specific channel by adjusting the corresponding DIP switch down.
NIGHT VISION ///
The camera includes IR LEDs, which allows viewing up to 5 feet in the dark when used with the adapter.
The IR LEDs are controlled by a photocell and are automatically turned on at low light level and off at high
light level. This helps to extend the battery life of the camera.
NOTE:
The range of the IR LEDs work best
with the AC adapter. The IR LED range is limited when used with alkaline batteries or the battery pack.
HELPFUL HINTS ///
The 21ST
™
Wireless Cameras
are suitable for indoor and outdoor use.
Please bear in mind the following points when choosing a mounting position:
■
The Camera Motion Sensor should not be more than 20 feet from where motion will occur.
■
The lower the Motion Sensor the closer it may need to be to the monitored area.
■
Ideal height for the Motion Sensor is 6 - 8 feet.
■
Before mounting and installing the cameras we recommend that you view the cameras
on the
Wireless Video Monitor/Receiver
so that you may then choose the best camera
viewing position.
■
Cameras should not be pointed directly into the sun or any bright light, as this may cause damage
to the camera.
■
Avoid areas where half the area is in bright sunlight and the other half is dark, such as in the
shadow of a building. Large light variations make it difficult for the camera.
CAMERA 2’S
DIP SWITCH
(IF USING)
CAMERA 3’S
DIP SWITCH
(IF USING)
CAMERA 1’S
DIP SWITCH
REAR VIEW OF CAMERA
