drainpipe
manual
Quantity
IMPORTANT:
The appliance must not bulit-in.
Unpacking:
All packing, must be removed before
using the appliance.
Check accessory:
Open the accessory bag and check the accessories.
Should the appliance be moved, it must be transported
vertically.
Malfunction
Possible Cause
Solution
Dryer does
not work
Drying results
unsatisfactory
Drum light does
not work(option)
Drying cycle ends
shortly after
programme starts.
"END" light
illuminated.
Drying cycle lasts
an unusually long
time
Mains plug is not plugged in.
Loading door is open.
Have you pressed the button?
Wrong programme selected.
Filter clogged.
Incorrect volume of laundry.
The sediment on humidity sensor.
Light bulb is defective.
Not enough washing loaded or
washing load is too dry for selected
programme.
Load volume is too big.
Select a different programme the next time
you dry(see "Drying Programme "section).
Clean lint filter.
Observe recommended loading volumes.
Replace light bulb.
Select higher drying level(e. g. Heavy instead
of Strong)
Reduce load volume.
Plug in at main socket.
Close loading door.
Press the button again.
note of the model, serial number and purchase date of your machine: the Service Center will require this
information.
If you are unable to identify or solve the problem, contact our service center. Before telephoning, make a
This appliance must be earthed. In case of failure or damage, earth can provide a minimum resistance
to reduce the possibility of electric shock. The power cord has grounding wire with device and power
cord with plug. Plug must be inserted into a properly installed and grounded socket(in accordance
with all local rules and standards).
Earth note
Water discharge
It’s not necessary to discharge the condensed water to the tank, it can
be drained out directly.change drainpipe.
Pull out the water pipe by means of the arrow direction ,Then install the
drainpipe.
Such as the pilers can be used if it is difficult to do.
Caution
!
Before use the machine, the packaging foam must be removed from
the drum.
1.Open the loading door.
2.Pull off adhesive strips from inside machine on top of drum.
3.Remove the two packaging foam from the machine.
Removing transport safety packaging foam
two packaging foam
12
