Eurotech DynaGate 10-12 Series, User Manual

Page: 79 / 94

DynaGATE 10-12 User manual Rev. 0-14 12 How to log in the Administration Console
12 H
OW TO LOG IN THE
A
DMINISTRATION
C
ONSOLE
This section describes how to enter the Administration Console to access the DynaGATE 10-12 Linux
Operating System.
To login the Administration Console, use one of the following methods:
l
Direct login via Console Port
l
Remote login via Secure Shell (SSH)
12.1 The default credentials
The default credentials are the following (case sensitive):
l
Username: root
l
Password: eurotech
12.2 How to login using the Console port
To log in using the Console port, complete the following steps:
1. Connect the USB-to-Serial cable adapter
1
between your development PC and the Console
connector of the DynaGATE 10-12
2. Start a terminal emulator program on your development PC (for example TeraTerm on Windows,
Minicom on Linux). Configure the serial port connection for: 115200, 8 bits, 1 stop bit, no parity, and
no flow control
3. At the Linux prompt, enter your credentials (see "The default credentials" above ).
You will obtain a video output like the following:
root
Password:
root@productname...:~#
12.3 How to login via Secure Shell (SSH)
The default (out-of-the-box) network configuration of your DynaGATE 10-12 is as follows:
l
eth0
o
Status: Enabled for LAN
o
Configure: Manually (Static IP)
o
IP Address: 172.16.0.1
o
Subnet Mask: 255.255.255.0
o
DHCP Server Enabled
l
eth1
o
Status: Enabled for WAN
o
Configure: DHCP (DHCP client)
l
wlan0
o
Status: Disabled
12.3.1 How to login via the eth0 port
DynaGATE 10-12 eth0 port is configured with the static IP address: 172.16.0.1/24.
To log in using eth0, complete the following steps:
1
This cable adapter has an end provided with a Male USB connector type A, and the other end provided with a 3-pin,
1.25 pitch, female receptacle housing. Contact Eurotech for further information.
79 / 94