APOLLO 1U ICE
Internal configuration
Remove any cables attached to installed PCI expansion cards before attempting
removal of the PCI module.
To remove the PCI Module, follow these steps:
1
Unplug the flexible riser connection to the APOLLO SBC.
Take care to pull on the plug-in connector rather than the flexible cable.
2
Disconnect the tamper detect cable from front panel breakout board assembly.
The PCI module is retained in the enclosure by formed lugs on the base, and one
retaining screw.
3
Unscrew the retainer and slide the PCI Module back to clear the lugs on the base,
and lift out.
Be careful of the tamper detect switch and cable when the PCI module is
removed.
To fit a PCI card:
1
Remove the blanking plate.
2
Plug the card into the riser.
3
Adjust and fix the support bracket to suit.
4
Tighten the retaining screw.
To install the PCI Module, reverse the procedure outlined above.
© 2007 Eurotech Ltd Issue C
23
