Instruction Manual MIXPRO 28 CLASSIC EUROPRO pag.20
CLEANING OF CHAMBER MIXING
1)
Remove the gearmotor power supply outlet;
2)
The machine can be externally cleaned with a sponge or damp cloth;
3)
Open the gearmotor mixing assembly;
4)
Extract the mixer and clean it with the metallic brush (standard
supplied);
5) Clean internally with water.
CLEANING THE HOPPER
At each change of product used it is advisable to clean the
hopper with cloth or water jet.
CLEANING THE MATERIAL HOSE
1) Disconnect the material conveying tube to the connection pulling the side
levers.
2) Insert the into the material conveying tube the two foam rubber balls
standard supplied ;
3)
Insert the two foam rubber balls supplied into the material transport tube;
4) Connect the service tap to the fast connection (standard sup-plied) ;
5) Connect the material conveying tube to the fast connection pulling the side
levers ;
6) Position the water pump selector on "Manual";
7) Open the service tap till the two foam rubber balls come out from
the opposite end;
ATTENTION:
before disconnecting the material conveying tube, it is compulsory to
check that the equipment is not under pressure.
