User manual - Jetmix 100-70
202202-561-ENG
P14
5. USE OF THE MIXER (continued)
5.2. STARTING UP
1.
If the mixer is coupled with a JETMIX 100, switch on the machine to check that it is working properly
(see 6.1.).
2.
Switch on the mixer, the display (A2) indicates AU. Turn the emergency stop button (AU) to deactivate
it.
3.
The display (A2) indicates OFF, press the ON/OFF button (6) to switch on the mixer, the light (L4)
lights up.
4. The display (A2) corresponds to the mixing speed from 0 to 100%, the display (B2) corresponds to
the water flow in litres per hour.
5.
Connect the mixer to the water supply with the quick coupling (L).
6. Place a bucket under the mixer outlet (O).
7.
Press the WATER BACK button (11) and then set the water flow rate to 250 L/h (indicated on the
display (B2)) using the control valve (M).
8. Put the mixer in manual mode by pressing the button (7), the light (L5) lights up.
9.
Set the mixing speed to 50% using the arrows (9) and (10).
10.
Break the powder bags on the grid (K) to fill the tank.
11. Press the MANU button (7), the mixer starts.
12.
Let the product flow into the bucket for about 20 seconds, until the mixing has stabilised. The product
will be very liquid at first, then reach the desired consistency, depending on the settings selected.
13.
If the product is too liquid, use the valve (M) to reduce the water flow. If the product is too dry, use
valve (M) to increase the water flow.
14. To adjust the setting, increase or decrease the speed on the display (A2) using buttons (9) and (10).
Increasing the speed will make the product drier, decreasing the speed will make it less dry.
15. When the desired texture is reached, press button (7) to put the mixer in STOP mode, the light (L6)
lights up.
16.
If the mixer is used alone, press button (7) again to return to manual mode, light (L5) will be lit.
17. If the mixer is coupled to the JETMIX 100, see 6.2.
