Page 10
DV 52 ST See-thru Gas Fireplace
rev.110329
Installation
Wiring
Gas Control and Pilot Wiring
DV 52 ST
Removing and Installing the Doors
The doors are removed in a few simple steps. Follow the steps below to remove the
horizontal access panel, unlatch the door buckles and remove the door. Replace in
reverse order.
Figure 28a.
Locate the door buckles. (Both Sides Typical)
Door Latch Hook
Door Latch Slot
Hand-hold
Release the Door Buckles
Figure 28.
Removing and Installing the Horizontal Access Panel
Locate the Door Buckles
Figure 28b.
Door Buckle Tool
1
Step 4:
Firmly grasp hand-hold end
of door buckle tool and place
the machined end in the slot
under door frame, as shown.
Figure 28c.
Step 2:
Step 3:
Step 1:
Remove the horizontal cover by plac-
ing fingers in both finger holes, then
pushing away from you and lifting
out. Place it aside during mainte-
nance or cleaning.
Install in reverse order.
Finger Holes
Remove the Horizontal Access Panel
DV 52 ST
Access Panel
Figure 26.
Wiring the
DV 52 ST
remote receiver.
Thermostat Wire
(supplied)
to thermocouple
to thermopile
