1. Remove the fan retaining nut (2) in clockwise direction and grille retaining nut [4]
counterclockwise then remove the two pieces.
2. Place the back grill (5) with the handle up noting the locating pegs.
3. Firmly tighten the grille retaining nut (4) for fixing the grill.
4. Place the blade (3) on the rod (6) until it contacts the retaining pin.
5. Fit the fan retaining nut (2) on the motor shaft. THIS HAS A LEFT HAND THREAD
6. Unscrew the screw on one of the grills. Place the front grill (1) on the back grill (5), the
small holes at the bottom of the grills must match in order to pass the screw. Set the
grids using the 3 clips then tighten the screw.
BASE ASSEMBLY
1. Insert the tube of the fan (10) in the base (11), and screw it on with the nut (12).
2. Insert the telescopic tube (8) in the leg tube (10), and secure the assembly firmly with the
adjustment screw (9).
3. Insert the upper part of the fan already mounted (7) on the telescopic tube (8) and firmly
attach to the screw positioned at the back.
HOW TO USE
It is best to select the fan position before connecting to mains supply. Always site the fan
on a suitable, flat, stable surface away from strong heat sources (eg direct sunlight)
1. Pull top button out for no oscillation. Push button in for oscillation
2. The fan can be tilted upward or downward to direct the air accordingly
3. Plug the power cord into a suitable power socket.
4. You can adjust the speed with the speed buttons: 0: Off - 1: slow - 2: Medium - 3: fast
MAINTENANCE
1. Always disconnect the appliance from the mains by switching it off and removing the
plug from the power outlet before cleaning.
2. It is advisable to use a neutral detergent and a soft cloth and to rub dry. Do not use
solvents, acidic detergents, petrol or alcohol etc. to clean the plastic components, as
these could be deformed or damaged.
3. Do not allow water to penetrate the motor housing during cleaning.
TECHNICAL DATA
Description: RETRO STAND FAN
Input Voltage: 220-240V ~50Hz
60 Watts