2
0
EN
Problem
LED
Alarm
LCD
Alarm Possible Solution
(LED model) or F5 is dis-
played (Display model).
o
o
F5
Switch off and then switch on the wash-
ing machine. In the fault persist contact an
authorised service centre.
(LED model) or F6 is dis-
played (Display model).
o
F6
Switch off and then switch on the wash-
ing machine. In the fault persist contact an
authorised service centre.
The door does not open
Make sure the red pilot lamp turns off.
Make the special function SOAK or RINSE
HOLD is not activated
Push the door from the door locking side
or give a slight tap and at the same time
pool it to open.
Make both the water inlet hose and drain
hose are whole and do not leak.
The washing detergent could not be ideal
or could be excessive.
Reduce the detergent quantity.
The washing machine fetch-
ing in water even when it is
off.
Reduce the pressure of water supply or
the water pressure pumping system (wa-
ter autoclave).
Close tap at the end washing.
The machine vibrates notice-
ably.
Ensure that the transportation screws
have been removed during installation.
clean. Ensure that the drain pump is
squashed and that the machine drains ef-
fectively.
Ensure using the correct detergent for
washing machine.
Make sure that the laundry is not amassed
or knotted and that the spin speed is ad-
equate for the laundry load. It so recom-
mended that for excessive laundry load
and less than half the nominal load capac-
ity set the spin speed to low.
Ensure that the machine is properly lev-
for any eventual feet imbalance compen-
sation the feet must regulated and lock
them in place with the locking knob (see
5
).
