Euronics Sole cleaning machine, Operation Manual, Page: 2 / 4

2
Questions Reason Troubleshooting
Machine doesn’t work
Loose power outlet Check power plug
Perception sensor
fault
Check the sensor indicator light.
Brush doesn’t work
Loose Brush
Adjust brush by hand（Check Routine Maintenance No. 4）.
Human absent, still work Sensor is blocked Make sure there is no obstruction above the sensor and clean the sensor surface.
Type Dimension Clean zone Dry zone Water tem. Tank
ESCD3 900×470×85mm 345×325mm 335×325mm 0-40℃ 4L
Voltage Power Noise Overload N.W
220V/50HZ 75W <60db 150Kg 25Kg
Sole cleaning machine
operation manuals
IV. Common trouble shooting
V. Specifications
4. Adjust the brushes: When the machine is running normally, you find the brushes do not work, then you
should adjust tension bolt tight.
① Power off, unlock two sides, lift cover;
② Find the brushes tension bolts (check Figure4.1), tighten it;
③ Both sides of a total 4 tension bolts are required to maintain a consistent adjustment, to ensure the equipment
work properly.
④ Connect the adapter, check brushes whether running normally, if the brushes still do not work, please repeat ①,
②,③ above, adjust the tension bolts, until the brush work.
Figure 4.1
Figure 3.3.1
Figure 3.3.2
Tension bolts