![Euromaid MW7140 Installation And Operating Instructions Manual Download Page 14](http://html1.mh-extra.com/html/euromaid/mw7140/mw7140_installation-and-operating-instructions-manual_2439473014.webp)
EN - 10
•
The mains cord of your washing machine
is e
q
uipped with an earthed plug. This
plug should always be inserted to an
earthed socket of 10 amps.
•
•
The plug should always be inserted to a
grounded socket of 10 amperes. The
fuse rating of the plug should also be 10
amperes.
If you do not have a suitable socket and
fuse conforming with this, please ensure
the work is carried out by a
q
ualified
electrician.
•
We do not take responsibility for
damage that occurs due to the use of
ungrounded e
q
uipment.
NOTE: Operating your machine with
low voltage will cause the life cycle of your
machine to be reduced and its
performance to be restricted.
3.4. Water Inlet Hose Connection
3/4”
10 mm
1
3
2
4
1. Your machine may have either a
single water inlet connection (cold)
or double water inlet connection (hot
and cold) depending on the machine
specifications. The white capped hose
should be connected to cold water
inlet and red capped hose to the hot
water inlet (if applicable).
•
To prevent water leaks at the joints,
either 1 or 2 nuts
(
depending on your
machines specification
s)
are supplied in
the packaging with the hose. Fit these
nuts to the ends of the water inlet hose
that connect to the water supply.
2. Connect new water inlet hoses to a ¾ ˝,
threaded tap.
•
Connect the white capped end of the
water inlet hose to the white water inlet
valve on the rear side of the machine
and the red capped end of the hose to
the red water inlet valve (if applicable).
•
Hand tighten the connections. If in any
doubt, consult a
q
ualified plumber.
•
Water flow with pressure of 0.1-1 Mpa
will allow your machine to operate at
optimum efficiency (pressure of 0.1 Mpa
means that more than 8 litres of water
per minute will flow through a fully
opened tap).
3. Once you have made all of the
connections, carefully turn the water
supply on and check for leaks.
4. Ensure that the new water inlet hoses
are not bent
,
broken
,
crushed or
resi
z
ed.
•
If your machine has a hot water inlet
connection, the temperature of the hot
water supply should not be higher than
70°C.
NOTE: Your Washing Machine must
only be connected to your water supply
~ 95 cm
~ 140 cm
~ 145 cm
~ 95 cm
0 – max. 100 cm
˜
95 cm
˜
150 cm