11 EN
restart the machine, please drain the water in
the water tank. Press “Start/Pause/Cancel”
button to start the programme after you have
emptied the water tank. The warning LED goes
off and the programme resumes operating.
Starting the Programme
1. Press “Start/Pause/Cancel” button to start
the programme.
2. “Start/Pause/Cancel” button will light up to
indicate that the programme has started.
Progress of programme
Progress of a running programme is shown
through the programme follow-up indicator.
At the beginning of every programme step, the
relevant indicator LED will light up and light
of the completed step will turn off.
“Drying”:
- Drying level will be illuminated during the whole
drying process until the drying degree reaches “
Ready to Iron “.
“ Ready to Iron “:
- Starts to illuminate when the drying degree
reaches “ Ready to Iron “ step and remains
illuminated until the next step.
“ Ready to Wear “:
- Starts to illuminate when the drying degree
reaches “ Ready to wear “ step and remains
illuminated until the next step.
“Final / Anti-creasing”:
- Illuminates when the programme comes to an
end and anti-creasing function is activated.
C
If more than one LED light up or
flash concurrently, it means there is
malfunctioning or a failure (please see,
Solution suggestions for problems).
Changing the programme after the
programme has started
You can use this feature after your machine has
started to dry your clothes under higher or lower
temperatures.
For example;
Press and hold the “Start/Pause/Cancel” button
for about 3 seconds to “Cancel” the programme
in order to select “Extra Dry” programme
instead of “Iron Dry” programme.
Select the “Extra Dry” programme by rotating
the programe knob.
Press “Start/Pause/Cancel” button to start the
programme.
C
The programme which is selected first will
go on even if the programme selection
button is moved and another programme
mode is selected while the machine is
operating. You must cancel the ongoing
programe in order to change the drying
programme. (See, Ending the programme
through canceling)
Adding/removing laundry in standby
mode
In order to add or take out laundry after the
start-up of the programme;
1. Press the “Start/Pause/Cancel” button to
switch the machine to “Pause” mode.
Drying process will stop.
2. Open the door at Pause position and close
it again after adding or taking out laundry.
3. Press “Start/Pause/Cancel” button to start
the programme.
C
Any laundry added after the drying process
was started may cause the already dried
clothes in the machine intermingle with wet
clothes and the result will be wet laundry
after the drying process is over.
C
Laundry may be added or taken out as
much as desired during a drying process,
but as this process will interrupt drying
continuously, it will extend the programme
duration and increase energy consumption.
Therefore, it is recommended to add
laundry before the drying programme is
started.
Child-proof lock
There is a childproof lock to prevent any
programme interruption due to the pressing of
keys while the programme is on. The loading
door and all keys except the “On/Off” key on
the panel are deactivated when the child-proof
lock is active.
In order to activate the childproof lock, press
on the “Start/Pause/Cancel” and “Cancel audio
warning” buttons simultaneously for 3 seconds.
To start a new programme after the programme
is over or to interrupt the programme, the
childproof lock should be deactivated. To
deactivate the childproof lock, press the same
buttons for 3 sec.
C
2 beeps when activating and 1 beep when
deactivating the child-proof lock is heard.
Summary of Contents for COND6KG
Page 1: ...Dryer COND6KG...