LAMPO Multifunction Unit
4
OPERATION
4.1
QUALIFIED OPERATORS INVOLVED IN SECTION
1
4.2 RESIDUAL RISKS FOR THE OPERATOR IN CHARGE OF THE OPERATION
Although many accident prevention devices have been used on the machine in order to eliminate the possible risks of use for the operator, it has some areas
defined “RESIDUAL RISK AREAS”.
These zones refer to moving parts of the machine that may pose an hazard to the operator, if s/he makes incorrect use or makes an assessment or
deactivation error, eluding the provisions contained in this manual. The machine is also provided with appropriate warnings placed on the areas with
residual risk that must be strictly observed.
The pictograms indicated below comply with standard UNI EN ISO 7010:2014.
During Machine operation, it is necessary to pay attention to the following residual risks, which are present when using the machine and which cannot be eliminated:
4.3 MACHINE PERFORMANCE
The machine performance refers to the maximum engine power and to the maximum electric pump power, shown in the table in point 1.5
4.4 USES NOT PERMITTED
The only permitted processing operations are described in the manual. Any other processing is to be considered FORBIDDEN and thus HAZARDOUS.
4.5 SAFETY FUNCTIONS
Periodically check the correct operation of all the safety devices.
THE MANUFACTURER allows the use of the machine to the Final User, during the work cycle, only under the condition that all the protections are active,
working and exactly in the same situation as provided for in the initial project, while only the qualified personnel
is allowed to use the machine
with partially disabled safety devices for maintenance, checks and calibration (the term "partially" indicates the possibility to exclude locally and temporarily,
by qualified personnel, the single protection that prevents a special type of maintenance, control or calibration. All the protections that do not prevent the work
of qualified personnel must remain active).
Personnel with qualification other than
(table Par. 0.6) must use the machine with fixed, mobile and electric protections fully active,
enabled and efficient as provided for by the original project.
The machine must be used and maintained by qualified operators authorised by the Final User who took part in the training provided by the
MANUFACTURER technicians.
The operators are obliged to report any deficiencies and/or potential dangerous situations that may occur to their direct managers.
The Final User has the duty to promptly inform the MANUFACTURER if s/he finds defects and/or malfunctions of the accident prevention systems
as well as any dangerous situation s/he becomes aware of.
It is strictly forbidden for the Final User and/or third parties (except for the duly authorised personnel of the MANUFACTURER) to make changes of
any kind and entity to the machine and its functions, as well as to this technical document.
In order to quickly identify the position of the safety systems present in the machine, their position is shown below. Emergency buttons
EMERGENCY MUSHROOM BUTTON: red mushroom button with yellow plate. It must be activated only
for the purpose of securing the system and the people who operate it, i.e. if the operator perceives a
hazard arising from the machine. The activation of the emergency button during the normal operation
of the machine causes its immediate stop. This button acts on a safety control unit that electrically
intercepts all the machine utilities.
EMERGENCY RESET: Following the emergency release, it is necessary to reactivate the auxiliary
devices by turning the selector to OFF and then to ON
21
Summary of Contents for LAMPO GREEN
Page 2: ......
