41
Putting into operation and control
Check before each use:
-
whether the infrared patio heater is not damaged;
-
whether the infrared patio heater is still attached firmly;
-
whether no objects, tarps, parasols, etc. are located within the indicated
safety distance;
-
whether the socket has the correct voltage (220-240V~50Hz) and that it is
earthed.
If everything is in order, you may put the plug into the socket.
To be certain that the infrared patio heater is operating without any problems,
observe the appliance closely for the first 10 to 15 minutes during first time use
(and again after a long period of not using it).
The infrared patio heater has a remote control that is operated by two AAA 1.5V
batteries. During use, point the remote control to the receiving point of the
infrared patio heater (on the electric part). Make sure that there are no obstacles
in between the remote control and the infrared patio heater.
Remove the batteries during off-season. That will give the remote control a
longer life.
Press the On/Off switch at the rear side of the infrared patio heater on ‘I’ (On).
Operating with a remote control
Button
Image
Description
Arrow up
Switch to a higher heating level (the
infrared heater has 6 different heating
levels)
Max
Switch immediately to the highest
heating level
Arrow
down
Switch to lower heating level
On
Press ON to start the appliance. The
infrared patio heater has a ‘slow start’ at
33% output.
After 4 seconds, the infrared patio heater
switches to the most recently used
output. During the initial use, the infrared
patio heater switches to 100% output
after 4 seconds.
Off
Press OFF to shut down the appliance
