EUROM Coolsilent 100 Wifi, Instruction Manual

Page: 44 / 64

44
Safety
The Coolsilent 100 is fitted with an overheating safeguard that switches the unit off if
it overheats. If this should occur, you must remove the plug from the socket and
leave the equipment to cool for at least 30 minutes. Remove the cause of overheating
- has the device been (partially) covered? Is it too close to a wall or another obstacle,
preventing it sucking in or dispelling sufficient air?
You can then use the device normally again but keep an eye on it for the first 30
minutes to ensure there are no further problems. If the device is showing signs of
problems or the overheating recurs, even though there is no obvious assignable
cause, ask your supplier or a recognised electrician to check/repair the unit.
Cleaning and maintenance
Note! Before cleaning or carrying out maintenance work on the air conditioning unit,
always switch off and remove the plug from the socket! Regular cleaning is vital in
order to keep the unit in good working order!
Cleaning the housing
Use a soft, damp cloth to wipe the housing.
Never use aggressive cleaning products, petrol, detergent, chemically-impregnated
cloths or other cleaning solutions. These could damage the housing. Never spray the
unit and ensure that water never penetrates the device! Dry the unit with a soft cloth.
Cleaning of the filters
Clean the filters every two weeks; air conditioning with dirty filters does not operate
properly. One filter is located behind the air intake grid at the back. You can easily
open this grid and remove the filter. The other filter is on the side / rear. Remove
both screws on top of the filter for this and remove the filter from the device. Use a
vacuum cleaner or tap the filters lightly to remove loose dust and dirt. Then rinse the
filters clean in, at most, lukewarm water (not warmer than 40°C.), potentially with a
mild, neutral cleaning agent. Let the filters dry thoroughly in the shade before placing
them back. Attention! Never operate the air conditioning without filters!
End of season cleaning
If the device is to be stored for a long period, you must take the following measures!
 Remove the condensed water. Run the unit for a few hours on fan function so that
the unit is completely dry inside.
 Then switch the air conditioning unit off and remove the plug from the socket.
 Clean the filters and reposition them or replace with a new ones.
 Unscrew the waste pipe from the device in order to prevent damage.
 Pack the air conditioning unit in its original packaging or in a plastic bag and place
in a dry place for storage. Place a heavy object on the unit.
 Store the device in a room smaller than 9,7m².
Troubleshooting and Error codes
Troubleshooting

The unit does not start if I press the ON/OFF button
 Is the plug in the socket?
 Is the earth leakage circuit breaker engaged? No power?