~ 31 ~
F =
automatic operation
K =
cooling
G =
de-humidification
L =
ventilation
H = Timer:
Use the higher/lower buttons to set the period of time for which the airco must work (only
the remote control).
J = Change °C-°F:
changes the temperature read-out on the display from °C to °F (only with remote
control).
USE
When your airco has been installed in accordance with the instructions and all safety regulations have
been taken into account you can insert the plug in the socket. Now press the on/off switch
– the airco
will switch on in the mode that it was in when it was switched off.
Attention!
During operation, if the internal water reservoir is full, the airco automatically pumps condensation
water away. This causes some noise. It stops automatically, after which the airco operation
resumes in the set mode.
The airco is fitted with a drain hose for condensed water (with cap), which let you manually empty
the internal water reservoir. Do this at least before moving the airco, and before you clean it up
after the season.
The airco has an operation resumption safety feature
– the device will not switch on for three
minute after being switched off, in order to protect the compressor.
Automatic operation
For cooling while the ventilation strength is controlled automatically.
1.
Press the button ‘Power’ (A)
2.
Press the ‘Mode’ (B) several times until the ‘automatic operation’ (1) icon lights up on the display. If
you are using the remote control, press F: automatic operation.
3. Set the desired temperature with buttons D and E (16-31°). The device will not work if the set
temperature is higher than the indoor temperature.
4. The fan speed is controlled automatically.
Cooling
To be used for cooling while the fan speed can be set as desired.
1.
Press the ‘Power’ button (A).
2.
Press the ‘Mode’ (B) button several times until the ‘cooling’ (2) icon lights up. If you are using the
remote control, press button K (cooling).
3. Set the temperature with buttons D and E (16-31°). The device will not work if the set temperature
