LUBE-MASTER R10
10(20)
TCM: ‡
TCM MainMenu
PortX: ‡
TCM MainMenu
TBA: ‡
Bottom area [m2]
TBA:1.000_ ‡
Bottom area [m2]
TBA:1.000 ‡
Bottom area [m2]
TCM: ‡
TCM MainMenu
PortX: ‡
TCM MainMenu
StopVol:1000 ‡
Stop vol [L]
StopVol:1000 ‡
Stop vol [L]
StopVol:1000 ‡
Stop vol [L]
5.5.1. Set the tank stop volume level
The tank stop volume set in the TCM is used to create a true graphic
representation of the analogue sensor status and start auto warning if that is
enabled. It should be set to the same value as in the PC database.
Enter menu
[TCM//PortX]
by scrolling with
or
.
At
PortX:
press
ENTER
.
Scroll to
StopVol:
using
or
.
Press
ENTER
to get the cursor.
Type the
stopr volume level of the tank
and press
ENTER
to
acknowledge. When the cursor disappears it is finished.
Press
EXIT
two times to leave Set-Up mode
5.5.2. Set tank bottom area
Setting the tank bottom area is only usable for a tank with the same
projected area throughout the total tank height.
For other tank forms the profil has to be downloaded to the TCM from a PC.
The area should be in square meters. When the area is typed in and
<ENTER> is pressed the volume for each step on the scale is calculated and
stored in the TCM.
Enter menu
[TCM//PortX]
by scrolling with
or
.
At
PortX:
press
ENTER
.
Scroll to
SFS:
using
or
.
Press
ENTER
to get the cursor.
Type the
sensor full scale value
and press
ENTER
to acknowledge. When
the cursor disappears it is finished.
Press
EXIT
two times to leave Set-Up mode.
5.5.3. To configure a TCM port for a tank that does not have a constant area
Each TCM port can handle tanks of any shape buy using a tank shape file. To upload a tank shape file to the
TCM module it must be connected to a PC with LUBE-Master WinTools installed. After the tank shape file
has been uploaded the TCM can be disconnected from the PC. For detailed information see the LUBE-
Master WinTools manual.