60000840_V_1_2.DOC
12/14
(1)
Headpiece
(2)
Fixation screws
(3)
Guide bearing
(4)
Pinhole bar
(5)
Lock nut
(6)
Crank handle
(7)
Height adjustable leg
(8)
Footstep
INSTALLATION
DANGER TO LIFE!
Please consider the
and the respective national norms during the
installation! The installation must only be carried out by an authorized dealer!
DIN 15560-27
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the loads. If you lack these qualifications, do not attempt the installation yourself, but
instead use a professional structural rigger. Improper installation can result in bodily injury and.or damage to
property.
The stand has to be installed out of the reach of people.
Loosen the fixation screws of the legs. Pull the legs out until the cross struts stand at a 90° angle to the legs.
Tighten the fixation screws of the legs.
In case of gravitational displacement or uneven ground surface, the lengthening of one leg corrects the
situation.
