00028844.DOC, Version 1.0
20/30
4.2 Overview
Overview on the control elements
1) SCENE buttons
Press the scene buttons to load or store relevant Scenes.
2) CHASE buttons
These buttons are used to load or store relevant Chases.
3) FIXTURE buttons
To select fixtures for setting, programming or recording.
4) Dimmer faders
To control and adjust relevant dimming level for each channel.
5) PAGE button
To select relevant Scene-page or Chase-page.
6) STEP / MIX / SEQ button
To activate the “STEP” function or switch between the Mix mode and the Sequence mode.
7) GROUP button
To select more fixtures while holding down this button simultaneously.
8) TAP SYNC button
Repeatedly tap this button to establish different chase rate.
9) AUDIO button
Used to activate audio sync of chase rate or set a scene at audio effect.
10) BLACKOUT button
Press this button to enable or disable relevant DMX output. When its LED is lit, that means relevant
DMX output is disabled. Press this button again the LED will be “off”, that means the DMX output is
reactivated.
11) SETUP button
Press this button for about 3 seconds to access the SETUP menu.
12) FOG MACHINE button
This button is used to control the Fog machine. Relevant LED will show you the different working states
(HEATING or READY).
13) DEL button
Press this button to delete relevant Scenes or Chases.
14) LCD Display
15) RECORD button
Press and hold down this button for about 5 seconds to access the Scene/Chase mode, and also use
this button to record Scenes or Chases.
16) ESC button
To cancel relevant operation or to exit.
17+18) UP/DOWN buttons
To select or adjust desired item or level during operation.
19) CH.PAGE button
Press this button to switch between CH 1-8 and CH 9-16. LED “off ” means 1-8 channels available,
while LED “on “ means 9-16 channels available.
